Advanced ConfigurationΒΆ
This section will take you through the more advanced configuration and tuning options for the vehicle.
- Analog Pins
- Advanced Failsafe
- Autopilot Output Mapping
- Auxiliary Functions
- Battery Voltage Compensation
- Bootloader Update
- BLHeli ESCs
- CAN Bus Setup
- Compass Setup (Advanced)
- Compass-less Operation
- Crash Detection
- DroneCAN Setup
- EKF (Extended Kalman Filter)
- EKF Affinity & Lane Switching
- EKF Sources and Selection
- Flight Time Recorder
- Flight Options
- Fly-By-Wire Low Altitude Limit
- FPort Setup
- GeoFencing Failsafe
- GPIOs
- GPS for Yaw (aka Moving Baseline)
- GPS for Altitude
- GPS/Non-GPS Transitions
- Ground Control Station Only Operation
- IMU Temperature Calibration
- Independent Watchdog
- In-Flight FTT and filter control
- Limiting Maximum Power Draw
- Limit Cycle Prevention
- LUA Scripting
- Magnetic Interference
- Magnetometer GeoPhys Array
- MAVLink2 Packet Signing (Security)
- Moving Vehicle Initialization
- Multiple Radio Control Receivers
- Network/Ethernet Setup
- Notification Devices (LEDs,Buzzer,etc.)
- Notch Filter Configuration
- Object Avoidance
- Optical Flow Sensor
- On Screen Displays (OSD)
- OSD Parameter Editor
- Parameter List (Full)
- Parameter Reset
- RC Input Channel Mapping (RCMAP)
- RC Options
- Redundant Telemetry
- Reverse Thrust Setup
- RunCam Camera Configuration and Control
- Safety Switch
- Sensor Position Offset Compensation
- Sensor Testing
- Serial Forwarding to DroneCAN
- Serial Port to Port Passthrough
- Serial Port Configuration
- Ship(Moving Vehicle) Takeoff/Landing
- Telemetry Port Setup
- Terrain Following
- Transmitter Based Tuning
- Video Stabilization (Gyroflow)
- Video Transmitter Control
- UBlox GPS Configuration
- Vibration Damping